Home > Pumps, Plumbing & Hose > Pumps > Bilge Pumps
Choose a sub category:
Rule Pump Adapters, Brackets, Y Fittings, etc.
Click on image to see ordering information.
Sort By:
Page of 1
Rule 1800 GPH 110 VAC Automatic Utility Pump - A53S - 110 VAC Jabsco "CYCLONE PUMP" Stainless Steel DC Motor / Pump Unit Attwood Tsunamai Series Bilge Pumps
Designed to remove water from basements, garages, stairwells, utility rooms, and other utility applications. Utilizes standard 110 V AC current. UL listed. Compact, efficient long-life motors Totally submersible Rust and corrosion proof Silent and vibration-free operation 110 VAC.
Double insulated pump motor is permanently lubricated • Snap-off strainer for easy cleaning • Comes with a three-year warranty • Heavy-duty thermoplastic housing protects pump from the most adverse conditions • Totally submersible in fresh or salt water.
Computerized automation eliminates need for float switches • Automatically checks for water every few minutes • Turns on when only 1" of water is detected • Never runs dry — Turns off automatically when pumping is complete or if impeller becomes jammed.
Garden hose and 90° Elbow Adaper for 1" NPT Pipe included.
Click on product image to view and order available models. Click on product image to view and order available models.
Attwood Sahara Series Automatic Bilge Pumps Attwood Waterbuster Portable Bilge Pumps - 4140-4 Johnson Pumps
Attwood Waterbuster Portable Bilge Pumps - 4140-4
List Price: $80.33
Our Price: $59.99
Click on product image to view and order available models. This submersible pump is a great way to remove unwanted water from boats, pool covers, aquariums and sump pits. Convenient and safe, too, because it needs no electrical cord – runs up to 5 hours on three alkaline D batteries. Excellent for use as a portable pump-out device for paddle boats, inflatables, duck boats, dingies and kayaks. Any craft that lacks a hard-wire, permenent electrical system.

6-3/8" high x 5-1/4"
Pumps up to 200 gallons per hour.
Includes 42" hose with garden-hose adapter for adding longer hose.
Lifts water to height of 40".

Note: Not to be used as a permanent bilge pump.
Click on product image to view and order available models.
Rule 350 GPH Pump with Automatic Float Switch Combo - 24-35A Rule 360-1100 G[H Round Bilge Pumps Rule 1500 - 2000 GPH Round Bilge Pumps
Includes:
Rule 360 Bilge Pump
Provides outstanding quality and value. It is economically priced and designed for small boats. 3/4” (19mm) discharge outlet. 12 Volts DC unless noted.
Rule-A-Matic® Float Switch - No. 35A
Float type switch which is good for all voltages to 110 VAC. Sealed construction protects internal circuits.
Click on product image to view and order available models. Click on product image to view and order available models.
Rule 3700 GPH Round Bilge Pumps Rule 4000 GPH Round Bilge Pumps Rule Automated Bilge Pumps
Click on product image to view and order available models. Click on product image to view and order available models. Click on product image to view and order available models.
Tie Down Engineering Rear Spring Hanger Perko Stainless Steel Debris Strainer - 70 Rule Gold Series Bilge Pumps
Perko Stainless Steel Debris Strainer - 70
List Price: $6.13
Our Price: $5.52
Click on product image to view and order available models. Extra measure of protection for use on round based Rule pumps up to 3700 GPH. Installs into existing strainer. Filters out excess debris and helps prevent jamming and failure. • Pump and switch are stand-alone products.
• Compact, efficient, long-life motors.
• Limited FIVE year warranty.
• Ability to run dry for short periods.
• Easy-clean, snap-lock strainer bases.
• Stainless steel shafts.
• Completely submersible.
• Marine-grade blocked wiring.
• Rust and corrosion protection.
• Silent and vibrationless operation.
• CE and ISO 8849 certification.
• Ignition protection.
12 VDC
Rule Bilge Pump with Built-In Back-Flow Preventer Jabsco Bilge/Livewell/Shower Sump/General Purpose Diaphram Pump Rule Submersible Bilge Pumps
  • Non-automatic (Use a panel and/or float switch.
  • Submersible
  • Ignition protected
  • High efficiency, low amp motor
  • Non burn-out when dry
  • Stainless steel shaft
  • Includes back-flow preventer
Flow rate: Nominal 16.3 Litres/min (4.3 USgallons/min)
Self-priming from dry up to 2.4m (7.8ft)
Run dry without damage.
Smooth flow.
Four piston, diaphragm pump.
Powerful heavy duty motor with thermal overload protection.
Snap-in ports.
Waterproof coating.
Meets USCG regulation 183.410 and EN ISO 8846 MARINE (Ignition Protection Standards).
Meets EN 50081-1 Electro-magnetic compatibility.
Complies with EN ISO 8849 MARINE Electric Bilge Pump.
Includes in-line pump filter.
Rule® submersible bilge pumps have set the standard for the industry for many years. They are the first choice of yachtsmen and commercial fishermen throughout the world. More innovations in bilge pump design have come from Rule® Industries than any other manufacturer.
All pumps include these Rule® quality features:
  • Commpact, efficient, maintenance-free
  • Silent running, vibrationless
  • Exclusive Rule® moisture-tight Teflon® seals
  • Ignition protected
  • Wong burn out when run dry
  • Anti-airlock feature
  • Positive snap-lock strainer base
Johnson Ultima 1000 GPH - 12V - Bilge Pump- 32-47260-003
The Ultima Bilge pump is a state of the art automatic bilge pump that uses advanced electronic sensing technology to detect the presence of water in the bilge area of a boat and consequently discharge of that water. It is built upon the proven UltimaSwitch technology which uses micro electrical fields to detect the presence of water. The Ultima Bilge pump is a sealed, submersible pump and electronic float switch that allows for a simple installation for the end user.
Easy-to-install Dura-Port discharge ports to eliminate stress cracking caused by over-tightened hose clamps. These pumps come with both a straight and a 90° smooth elbow 3/4” Dura-Port.
Lip seal.
12 VDC.